資料介紹
The TL494 incorporate on a single monolithic chip all the functions
required in the construction of a pulse-width-modulation control,
these devices offer the systems engineer the flexibility to tailor ORDERING INFORMATION
the power supply control circuitry to his application.
The TL494 contains an error amplifier, an on-chip adjustable
oscillator, a dead-time control comparator, pulse-steering control
flip-flop, a 5-volt, 5% precision regulator, and output-control circuit.
The error amplifier exhibits a common-mode voltage range from -0.3 volts to Vcc -2 volts. The dead-time control
comparator has a fixed offset that provides approximately 5% dead time when externally altered. The on-chip
oscillator may be bypassed by terminating R T (pin 6) to the reference output and providing a sawtooth in put to
CT (pin 5), or it may be used to drive the common circuits in synchronous multiple-rail power supplies. The
uncommited output transistors provide either common-emitter or emitter-follower output capability. Each Device
provides for push-pull or single-ended output operation, which may be selected through the output-control funct
-ion. The architecture of these devices prohibits the possibility of either output being pulsed twice during push
-pull operation.
required in the construction of a pulse-width-modulation control,
these devices offer the systems engineer the flexibility to tailor ORDERING INFORMATION
the power supply control circuitry to his application.
The TL494 contains an error amplifier, an on-chip adjustable
oscillator, a dead-time control comparator, pulse-steering control
flip-flop, a 5-volt, 5% precision regulator, and output-control circuit.
The error amplifier exhibits a common-mode voltage range from -0.3 volts to Vcc -2 volts. The dead-time control
comparator has a fixed offset that provides approximately 5% dead time when externally altered. The on-chip
oscillator may be bypassed by terminating R T (pin 6) to the reference output and providing a sawtooth in put to
CT (pin 5), or it may be used to drive the common circuits in synchronous multiple-rail power supplies. The
uncommited output transistors provide either common-emitter or emitter-follower output capability. Each Device
provides for push-pull or single-ended output operation, which may be selected through the output-control funct
-ion. The architecture of these devices prohibits the possibility of either output being pulsed twice during push
-pull operation.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- TL494芯片內部原理框圖 35次下載
- 基于TL494的推挽式開關電源
- 脈寬調制控制電路TL494數據手冊 94次下載
- TL494構成的穩壓逆變器電路 162次下載
- multisim 10/11仿真模型的tl494元件下載 107次下載
- 基于TL494小功率逆變器設計方案資料下載 161次下載
- Pulse Width Modulation 0次下載
- TL494逆變電源電路圖 1086次下載
- TL1451A,pdf(Dual Pulse-Width-M
- TL1451A-Q1,pdf(Dual Pulse-Widt
- TL5001,TL5001A,pdf(Pulse-Width
- TL5001A-Q1,pdf(Pulse-Width-Mod
- UTC TL1451 LINEAR INTEGRATED C
- 電壓驅動型脈寬調制器TL494
- TL494, NCV494 pdf datasheet (S
- TL494工作原理及典型電路 3.6w次閱讀
- TL494如何驅動全橋或半橋? 1.9w次閱讀
- 一種由TL494為控制核心的脈寬調制技術 4364次閱讀
- TL494檢測方法和TL494各腳電壓值介紹 23.7w次閱讀
- TL494實現單回路控制器及引腳功能詳解 1.6w次閱讀
- TL494工作原理圖解(引腳功能_內部結構_參數及開關電源電路) 54w次閱讀
- TL494推挽式輸出的電路設計(基于TL494的H橋直流電機控制系統) 1.9w次閱讀
- 由TL494構成的恒流閉環控制電路的設計與實現 2.1w次閱讀
- TL494控制BUCK型開關電源電路 4.9w次閱讀
- 基于TL494和IR2110的斷路器操作電源的設計電路 1w次閱讀
- 基于TL494的PWM脈寬調制等速送絲電路 9580次閱讀
- TL494脈寬調制器集成電路的設計與實現 1.4w次閱讀
- 基于TL494開關電源的電路設計 4.5w次閱讀
- 用PWM控制集成電路TL494實現單回路控制器 8292次閱讀
- tl494簡單逆變器電路分析 8.1w次閱讀
下載排行
本周
- 1ADE-12H混頻器規格書
- 0.28 MB | 1次下載 | 5 積分
- 2AD9984A高性能10位顯示接口英文手冊
- 0.49 MB | 1次下載 | 5 積分
- 351開發板芯片資料
- 14.95 MB | 1次下載 | 1 積分
- 4用TL431LI-Q1監控電流供應
- 176.71KB | 1次下載 | 免費
- 5十進制數據轉十六進制字符_轉ASCII碼
- 0.01 MB | 次下載 | 免費
- 6使用TRF7970A進行NFC主動和被動點對點通信
- 926.87KB | 次下載 | 免費
- 7LP8864-Q1 LP8864S-Q1 LP8866-Q1和LP8866S-Q1診斷說明和故障處理程序
- 577.42KB | 次下載 | 免費
- 8將設計移植到LP3470A低lq電壓監控器,以改善電源監控
- 115.28KB | 次下載 | 免費
本月
- 1HFSS電磁仿真設計應用詳解PDF電子教程免費下載
- 24.30 MB | 129次下載 | 1 積分
- 2正激、反激、推挽、全橋、半橋區別和特點
- 0.91 MB | 36次下載 | 1 積分
- 3GBT 4706.1-2024家用和類似用途電器的安全第1部分:通用要求
- 7.43 MB | 20次下載 | 免費
- 4在設計中使用MOSFET瞬態熱阻抗曲線
- 1.57MB | 15次下載 | 免費
- 5幾張電動車充電器電路圖
- 0.23 MB | 9次下載 | 1 積分
- 6AD18學習筆記
- 14.47 MB | 8次下載 | 2 積分
- 7H橋中的電流感測
- 545.39KB | 7次下載 | 免費
- 8電機驅動器電路板布局的最佳實踐
- 3.03MB | 6次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935113次下載 | 10 積分
- 2開源硬件-PMP21529.1-4 開關降壓/升壓雙向直流/直流轉換器 PCB layout 設計
- 1.48MB | 420061次下載 | 10 積分
- 3Altium DXP2002下載入口
- 未知 | 233084次下載 | 10 積分
- 4電路仿真軟件multisim 10.0免費下載
- 340992 | 191360次下載 | 10 積分
- 5十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183329次下載 | 10 積分
- 6labview8.5下載
- 未知 | 81578次下載 | 10 積分
- 7Keil工具M(jìn)DK-Arm免費下載
- 0.02 MB | 73804次下載 | 10 積分
- 8LabVIEW 8.6下載
- 未知 | 65985次下載 | 10 積分
評論
查看更多