資料介紹
The EL6211 is a three-channel laser
diode current amplifier that provides
controlled current to a grounded laser
diode. Channels 2 and 3 should be used as the write
channels, with switching speeds of less than two
nanoseconds rise/fall time. All three channels are summed
together at the IOUT output, allowing the user to create
multilevel waveforms in order to optimize laser diode
performance. The level of the output current is set by an
analog voltage applied to an external resistor which converts
the voltage into a current at the IIN pin (virtually ground).
An on-chip 500MHz oscillator is provided to allow output
current modulation when in any mode. This is turned on
when the OSCEN pin is held high. Complete control of
amplitude and frequency is set by two external resistors
connected to ground at pins RFREQ and RAMP (see graphs
in this data sheet for further explanation).
Output current pulses are enabled when an ‘L’ signal is
applied to the OUTEN pin. No output current flows when
OUTEN is ‘H’, and additional laser diode protection is
provided since the OUTEN input will float high when open.
Complete IOUT shutoff is also achieved by holding the
ENABLE pin low, which will override the OUTEN control
pins.
The external resistors allow the user to accurately and
independently set each amplifier transconductance by
applying a voltage to each resistor, without restriction on the
voltage range, thus ensuring broad voltage DAC
compatibility. Alternatively, the IIN pin can be biased from a
current DAC or other current source.
diode current amplifier that provides
controlled current to a grounded laser
diode. Channels 2 and 3 should be used as the write
channels, with switching speeds of less than two
nanoseconds rise/fall time. All three channels are summed
together at the IOUT output, allowing the user to create
multilevel waveforms in order to optimize laser diode
performance. The level of the output current is set by an
analog voltage applied to an external resistor which converts
the voltage into a current at the IIN pin (virtually ground).
An on-chip 500MHz oscillator is provided to allow output
current modulation when in any mode. This is turned on
when the OSCEN pin is held high. Complete control of
amplitude and frequency is set by two external resistors
connected to ground at pins RFREQ and RAMP (see graphs
in this data sheet for further explanation).
Output current pulses are enabled when an ‘L’ signal is
applied to the OUTEN pin. No output current flows when
OUTEN is ‘H’, and additional laser diode protection is
provided since the OUTEN input will float high when open.
Complete IOUT shutoff is also achieved by holding the
ENABLE pin low, which will override the OUTEN control
pins.
The external resistors allow the user to accurately and
independently set each amplifier transconductance by
applying a voltage to each resistor, without restriction on the
voltage range, thus ensuring broad voltage DAC
compatibility. Alternatively, the IIN pin can be biased from a
current DAC or other current source.
下載該資料的人也在下載
下載該資料的人還在閱讀
更多 >
- AAT2784,pdf datasheet(3-Channe
- LM3431,pdf datasheet (3-Channe
- AD5255,pdf datasheet (3-Channe
- 6211.pdf 電子管資料數據手冊
- EL7581 pdf datasheet (3-Channe
- EL7583 pdf datasheet (3-Channe
- EL7412 pdf datasheet (Power MO
- EL6245 pdf datasheet (3-Channe
- EL6244 pdf datasheet (3-Channe
- EL6224 pdf datasheet (3-Channe
- EL6216 pdf datasheet (3-Channe
- EL6216 pdf datasheet (3-Channe
- EL6215 pdf datasheet (3-Channe
- EL6173 pdf datasheet (3-Channe
- EL6146 pdf datasheet (4-Channe
- PDF輸出時出現錯誤提醒的解決方案 1185次閱讀
- 萬興PDF密碼如何查看列出的權限 835次閱讀
- EL1529IL-T13 500V/μs的高轉換速率、電流控制引腳 640次閱讀
- Select、Switch組件的使用 965次閱讀
- 分享一個快速閱讀datasheet的方法 2311次閱讀
- 帶EL34的20W功率管/電子管功放電路圖 1.4w次閱讀
- 高性能固態激光調制振蕩器EL6200C的功能及應用設計 3229次閱讀
- 5G時代到來,各個國家的2G/3G也將開始“退休” 752次閱讀
- 如何閱讀Datasheet,是作為電子工程師的必備技能! 7837次閱讀
- AD9如何簡單快速的制作出原理圖符號 7441次閱讀
- 光敏電阻光控燈電路圖大全(太陽能/晶閘管/光控開關) 7.2w次閱讀
- 使用pdf解析可以用來讀取PDF文件中字符串文本,圖片數據 1.3w次閱讀
- 讀Datasheet英文原文的原因分析 4314次閱讀
- adc0809中文資料下載 adc0809引腳圖封裝及應用電路 2w次閱讀
- 用EL156構建25W單端甲類膽機電路 2.8w次閱讀
下載排行
本周
- 1基于波形捕獲的超聲波傳感水流量計量技術應用說明
- 1.01MB | 1次下載 | 免費
- 2TMS320F2837x與TMS320F2838x之間的移植應用說明
- 312.67KB | 1次下載 | 免費
- 3ADE-12H混頻器規格書
- 0.28 MB | 1次下載 | 5 積分
- 4AD9984A高性能10位顯示接口英文手冊
- 0.49 MB | 1次下載 | 5 積分
- 551開發板芯片資料
- 14.95 MB | 1次下載 | 1 積分
- 6用TL431LI-Q1監控電流供應
- 176.71KB | 1次下載 | 免費
- 7具有霍爾效應開關的 HMI 翹板開關應用說明
- 3.22MB | 次下載 | 免費
- 8評估AFE74xx的跳頻能力應用說明
- 1.35MB | 次下載 | 免費
本月
- 1HFSS電磁仿真設計應用詳解PDF電子教程免費下載
- 24.30 MB | 129次下載 | 1 積分
- 2正激、反激、推挽、全橋、半橋區別和特點
- 0.91 MB | 36次下載 | 1 積分
- 3GBT 4706.1-2024家用和類似用途電器的安全第1部分:通用要求
- 7.43 MB | 18次下載 | 免費
- 4在設計中使用MOSFET瞬態熱阻抗曲線
- 1.57MB | 15次下載 | 免費
- 5幾張電動車充電器電路圖
- 0.23 MB | 8次下載 | 1 積分
- 6AD18學習筆記
- 14.47 MB | 8次下載 | 2 積分
- 7H橋中的電流感測
- 545.39KB | 7次下載 | 免費
- 8電機驅動器電路板布局的最佳實踐
- 3.03MB | 6次下載 | 免費
總榜
- 1matlab軟件下載入口
- 未知 | 935113次下載 | 10 積分
- 2開源硬件-PMP21529.1-4 開關降壓/升壓雙向直流/直流轉換器 PCB layout 設計
- 1.48MB | 420061次下載 | 10 積分
- 3Altium DXP2002下載入口
- 未知 | 233084次下載 | 10 積分
- 4電路仿真軟件multisim 10.0免費下載
- 340992 | 191360次下載 | 10 積分
- 5十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183329次下載 | 10 積分
- 6labview8.5下載
- 未知 | 81578次下載 | 10 積分
- 7Keil工具MDK-Arm免費下載
- 0.02 MB | 73804次下載 | 10 積分
- 8LabVIEW 8.6下載
- 未知 | 65985次下載 | 10 積分
評論
查看更多