資料介紹
To assure proper communication on the three SPI lines, it
is necessary to connect ground on the programmer to
ground on the target (GND)。
To enter and stay in Serial programming mode, the AVR
microcontroller reset line has to be kept active (low)。 Also,
to perform a Chip Erase, the Reset has to be pulsed to end
the Chip Erase cycle. To ease the programming task, it is
preferred to let the programmer take control of the target
microcontroller reset line to automate this process using a
fourth control line (Reset)。
To allow programming of targets running at any allowed
voltage (2.7V - 6.0V), the programmer can draw power
from the target system (VCC)。 This eliminate the need for a
separate power supply for the programmer. Alternatively,
the target system can be supplied from the programmer at
programming time, eliminating the need to power the target
system through its regular power connector for the duration
of the programming cycle.
Figure 2 shows the connector used by this In-System programmer to connect to the target system. The standard
connector supplied is a 2 x 3 pin header contact, with pin
spacing of 100 mils.
- AVR的自編程功能
- Practical-Programming-on-Android-Introduction
- YNH-910 收款機主板規格書
- The Linux Programming Interface - A Linux and UNIX System Programming Handbook 7次下載
- XAPP424 - 嵌入式JTAG ACE播放器 20次下載
- PLD Programming Using VHDL 0次下載
- 8位AVR單片機產品手冊下載
- LPC1300系列產品勘誤數據手冊
- FGPAs應用資料
- 對16位微控制器C163-16F內的128 KBytes閃速
- JTAG先進的功能和系統設計,JTAG Advanced C
- 用標準連續矢量格式文件對XC9500器件在系統編程,并用自動
- 用標準連續矢量格式文件對XC9500器件在系統編程,并用自動
- C5xx / 80C5xx In-System FLASH
- LPC2000 pdf datasheet
- Microchip AVR DD系列微控制器產品特性 490次閱讀
- AVR單片機實現輪胎內徑測量系統的設計 1062次閱讀
- 微雪電子USB AVR JTAG ICE XPII下載器簡介 4040次閱讀
- 微雪電子AVR JTAG仿真器簡介 2601次閱讀
- 碩數物聯科技RSC-910主板介紹 2317次閱讀
- AVR單片機與CPLD的通信設計 1100次閱讀
- AVR單片機的串口查詢設計 901次閱讀
- AVR單片機的優勢特征及未來發展展望 5705次閱讀
- 華為PTN910時鐘接口指標_參數及特點介紹 1.4w次閱讀
- 為什么要選擇AVR單片機? 1728次閱讀
- avr單片機功能特性介紹 1403次閱讀
- avr和arduino之間有什么關系?avr單片機和arduino的優點分析 3w次閱讀
- AVR單片機的主要特性 895次閱讀
- FPGA開發之算法開發System Generator 7679次閱讀
- AVR單片機有什么優點_為什么要選擇AVR單片機 2420次閱讀
下載排行
本周
- 1FS4059B帶NTC升壓型兩節鋰電池充電管理IC數據手冊
- 3.24 MB | 1次下載 | 免費
- 2基于波形捕獲的超聲波傳感水流量計量技術應用說明
- 1.01MB | 1次下載 | 免費
- 3ADE-12H混頻器規格書
- 0.28 MB | 1次下載 | 5 積分
- 4AD9984A高性能10位顯示接口英文手冊
- 0.49 MB | 1次下載 | 5 積分
- 551開發板芯片資料
- 14.95 MB | 1次下載 | 1 積分
- 6用TL431LI-Q1監控電流供應
- 176.71KB | 1次下載 | 免費
- 7Q1和非Q1器件的TPS54340/360/540/560和TPS54340B/360B/540B/560B之間的差異
- 123.6KB | 次下載 | 免費
- 8TPS512xx MOSFET驅動電路設計指南
- 886.86KB | 次下載 | 免費
本月
- 1HFSS電磁仿真設計應用詳解PDF電子教程免費下載
- 24.30 MB | 129次下載 | 1 積分
- 2繼電保護原理
- 2.80 MB | 42次下載 | 免費
- 3正激、反激、推挽、全橋、半橋區別和特點
- 0.91 MB | 36次下載 | 1 積分
- 4GBT 4706.1-2024家用和類似用途電器的安全第1部分:通用要求
- 7.43 MB | 18次下載 | 免費
- 5在設計中使用MOSFET瞬態熱阻抗曲線
- 1.57MB | 15次下載 | 免費
- 6AD18學習筆記
- 14.47 MB | 8次下載 | 2 積分
- 7H橋中的電流感測
- 545.39KB | 7次下載 | 免費
- 8幾張電動車充電器電路圖
- 0.23 MB | 6次下載 | 1 積分
總榜
- 1matlab軟件下載入口
- 未知 | 935113次下載 | 10 積分
- 2開源硬件-PMP21529.1-4 開關降壓/升壓雙向直流/直流轉換器 PCB layout 設計
- 1.48MB | 420061次下載 | 10 積分
- 3Altium DXP2002下載入口
- 未知 | 233084次下載 | 10 積分
- 4電路仿真軟件multisim 10.0免費下載
- 340992 | 191360次下載 | 10 積分
- 5十天學會AVR單片機與C語言視頻教程 下載
- 158M | 183329次下載 | 10 積分
- 6labview8.5下載
- 未知 | 81578次下載 | 10 積分
- 7Keil工具M(jìn)DK-Arm免費下載
- 0.02 MB | 73804次下載 | 10 積分
- 8LabVIEW 8.6下載
- 未知 | 65985次下載 | 10 積分
評論
查看更多